5 January, 2019
Elscint Vibratory Bowl Feeder with Chain Elevator for Cup feeding
Elscint recently manufactured and supplied a vibratory bowl feeder with a double chain elevator for feeding of bearing cups having diameter ranging from dia 50 mm to dia 100 mm and having width 15 mm to 30 mm. Being bearing cups, the cups were conical and hence orientation was required with the bigger side up. For feeding these, Elscint used a cylindrical bowl having diameter of 800 mm, mounted of vibratory Drive Model 630, which is a very heavy and sturdy drive with four coils. Additionally, Elscint suggested a hopper having 75 ltr. capacity for extra loading capacity as the cups were very large and the bowl did not accommodate many cups.
The bearing cups were loaded in the hopper, below which an Elscint linear vibrator with a tray was mounted. With the help of a level controller placed inside the vibratory bowl feeder, the linear vibrator was actuated to start / stop depending upon the level of components present in the bowl. This ensured that the number of bearing cups in the bowl were always optimum for proper and fast feeding.
The vibratory bowl feeder was used only to circulate the bearing cups and ensuring that the cups which were entangled into each other, were segregated for feeding. Further, 2 parallel vertical slits were provided at the periphery of the bowl from where the double chain elevator picked up the bearing cups and took them upto a height of 2 mtrs. From there the cups were dropped onto a conveyor with the required orientation (bigger side up). Speed of between 60 parts to 80 parts per minute was achieved (in the two rows).
There were no adjustments required in the hopper and the bowl as all the sizes would fit in the same without any changeover required. However, a minor adjustment was given with a knob on the elevator for the smaller and bigger sizes of cups. This ensured even an unskilled operator would be able to do the changeover and that too within 2 minutes.
The linear tray and the bowl was coated with Elscnthane PU to ensure reduced noise and easy flow of parts. As with all Elscint equipment, the build quality was very sturdy and wearable parts were screwed for easy replacement in the future, if the requirement arose. Secondly, all the parts used were Elscint standard and hence, availability of spares is never an issue.