6 July, 2018
Elscint, recently manufactured and exported a vibratory bowl feeder to feed O Rings having diameter 20 mm x 1 mm thickness to Spain. The requirement was to feed the O rings in “Flat” orientation at a speed of 50 O Rings per minute. As it was being exported to Europe, the aesthetics was very important.
23 June, 2018
Elscint recently manufactured and exported a set of two vibratory bowl feeders to Spain. One bowl feeder was for feeding of plastic insert with the orientation of pointed side up and the other was for feeding of a metal clip. The orientation of the metal clip was “hanging on a rail”. The parts being small
19 June, 2018
Many times, vibratory bowl feeders are used in machines where there is a PLC. If proper care is not taken during the wiring, it results in there being problems with the functioning of the vibratory feeders. It can result in variation in the speed or else can result in the vibratory feeders behaving irrationally. Hence,
11 June, 2018
Elscint has uploaded a video showing the maintenance aspects as well as the installation and commissioning procedures for its Model 160. You can watch the video here. The video covers the regular maintenance points with respect to Model 160 vibratory bowl feeder. A total of 15 points are covered. The reason a separate video is
26 May, 2018
Usually, parts like bolts, pins and rivets are fed in Head Up or Axial Position (Head leading or trialing) through a Vibratory Bowl Feeder. However, recently, a customer approached Elscint to feed these parts in Head Down orientation. All these parts, bolts, rivets and pins with head were to be fed to the same vision
18 May, 2018
Elscint recently supplied seven vibratory bowl feeders for a multinational company having locations at 3 places in India for feeding of Flare Nuts to their Flaring Machines. Most flare nuts are having the across flat and threading size same (10 mm) and the across corner is 11 mm. Lengths differ. The requirement is to get
5 May, 2018
Elscint recently supplied five vibratory bowl feeders for a special application. In fact this was a third repeat order, the previous one for five and eight bowl feeders were delivered in 2014 and 2017 respectively. As all the earlier supplied bowl feeders have been working without any problem for the last 4 years, the customer
25 April, 2018
Elscint recently manufactured and exported a set of two vibratory bowl feeders along with a spare bowl to Norway. It was for an old customer of Elscint, who has purchasing similar bowl feeders from Elscint since 2012 on a regular basis. It was for feeding rollers having diameter 9 mm x 15 mm length. The
18 April, 2018
Elscint recently manufactured a vibratory feeding systems for feeding of nuclear pallets to a centerless grinding machine. The pellets were having diameter 14 mm to 16 mm and length too varied between 15 mm to 18 mm. Handling of nuclear pellets is hazardous for the operator and hence the customer wanted to automate his process.
9 April, 2018
Elscint recently completed an order for a double head Automatic Tapping Machine. There were three different components which required tapping. The tap pitch was different for each of these 3 components. Additionally, each of the components required left hand and right hand tapping. All these changeovers were required to be done in the same machine.